CDQ2B-X2839 系列 日本SMC偏心销移位气缸

CDQ2B-X2839 系列 日本SMC偏心销移位气缸

节省空间气缸，薄形、装置紧凑型设计
可在4面安装小型磁性开关 ( Φ12到Φ25的是两面)
磁性开关不突出表面
新追加双耳环型、小型脚座型
：减少5%到13%(和以前的CQ2系列相比)
安装螺丝同捆，设定了杆端安装件的型号(省去了分别订购气缸和支件的时间)

CDQ2B-X2839 系列 日本SMC偏心销移位气缸
带磁性开关 (CDQ2系列: CDQ2, CDQ2W, CDQ2K, CDQ2KW,CDQP2, CDQ2□S, CDBQ2)
When a work piece is mounted on the piston rod end, connect
them aligning the center of piston rod and a work piece. If they
are off-center, lateral load is generated and phenomena mentioned
in (1) may occur. In order not to apply the off-center load,
use of a floating joint or simple joint is recommended.
3. Simultaneous use of multiple cylinders
It is difficult to control the speed of pneumatic cylinders. The following
conditions cause speed change: change in supply pressure,
load, temperature and lubrication, performance difference
of each cylinder, deterioration of each part over time, etc. Aspeed
controller can be used to control the speed of multiple cylinders
simultaneously for a short period of time, but depending
on conditions, it may not work as desired. If multiple cylinders
cannot operate simultaneously, unreasonable force is applied
to the piston rod because cylinder positions may not be the
same. This may cause abnormal friction of seals and bearings,
and galling of cylinder tubes and pistons. Do not use an application
to operate several cylinders simultaneously by adjusting
cylinder speed. If this is inevitable, use a high rigid guide
against load, so that the cylinder is not damaged even when the
each cylinder output is slightly different.